Body fat calculator: the US Navy tape method
Estimate your body fat percentage with a tape measure. This calculator uses the US Navy method: a few measurements and your height give an estimate of your mix of muscle and fat.
No clinic, no scales, no special kit. Basis keeps it simple: a tape measure and two minutes.
We use the US Navy circumference equations, published by Hodgdon and Beckett at the Naval Health Research Center (1984). They're a tape-measure estimate, not a scan.
How to measure (2 minutes)
- Use a soft tape, on bare skin, snug but not squashing. Read it to the nearest half centimetre (or quarter inch).
- Stand tall and relaxed, and breathe out normally before you read the tape. No sucking in.
- Measure twice and use the average.
Your estimated body fat
That's the share of your body weight that's estimated to be fat. The rest is everything else: muscle, bone, organs and water. Together that's your body composition, your mix of muscle and fat.
Where it sits on a common chart
The chart is a general guide from the American Council on Exercise, not a health check. It doesn't account for age, and with this method's margin you could sit in the range next door.
See the full chart
Tape-measure methods have a real margin. In the original Navy studies, estimates were usually within about 3.5 percentage points of a lab measurement, and some people were further out. Treat it as a range, not an exact figure.
One reading is a snapshot. The trend is the story. Measure the same way every few weeks and watch which way it's heading.
Your measurements stay on this device. If you unlock your plan, we keep the calculated results — not those measurements — so we can email it to you. Clear what's on this device any time with Forget my numbers.
This link rebuilds your plan. Keep it somewhere safe. Anyone with it can see your numbers.
Get your full targets and plan
How to remeasure so your numbers compare fairly, and how your body fat connects to your daily energy needs.
How to remeasure
Same time of day, ideally first thing in the morning. Same tape, same spots, same snug feel. Breathe out normally before you read it. Every 4 to 6 weeks is plenty. Day-to-day changes are mostly noise.
How it connects to your energy needs
The TDEE calculator uses your weight, not what that weight is made of. Two people who weigh the same can use different amounts of energy, partly because muscle uses a bit more energy at rest than fat. Your body fat estimate adds that context. It isn't a nutrition plan on its own.
Work out your daily energy next, with the same honest method shown.
This is an estimate for general information, not medical advice. If you have a health condition or you're new to exercise, check with your GP or a health professional.
Next: work out your daily energyHow does the US Navy body fat calculator work?
It estimates body fat from your height and a few tape measurements (neck and waist, plus hips for women), using equations published by US Navy researchers Hodgdon and Beckett in 1984. They're built from measurements compared against underwater weighing. For men, the equation uses waist minus neck; for women, waist plus hips minus neck. Both are converted to a percentage with the Siri equation (495 ÷ body density − 450).
How accurate is the Navy body fat method?
It's a reasonable estimate, but not exact. In the original studies it was usually within about 3.5 percentage points of a lab measurement, and later comparisons found similar or wider gaps for some people.
Where do I measure my waist and neck?
Measure your neck just below the Adam's apple. Men measure the waist around the belly button. Women measure the waist at the narrowest point and the hips at the widest part of the bottom.
What's a typical body fat percentage?
It depends on sex: women naturally carry more essential fat than men. On the American Council on Exercise chart, the average range is 25–31% for women and 18–24% for men. It's a general guide, not a target, and it doesn't account for age. Your own trend, measured the same way, tells you more than any chart.
Is the tape method as good as a DEXA scan?
No. A DEXA scan is a more detailed measure, while the tape method is a quick, free estimate. It's most useful for tracking your own trend over time, measured the same way.
How often should I measure my body fat?
Every 4 to 6 weeks is plenty for most people, because small day-to-day changes are mostly noise. Measure at the same time of day, in the same way.
Who is this calculator less accurate for?
It may be less accurate for people who don't resemble the original study groups, which were US Navy personnel (men 18–56, women 18–44). That includes older adults, very muscular people and pregnant women. If you need a precise measure, ask a health professional.
Sources
- Hodgdon JA, Beckett MB (1984). Prediction of percent body fat for U.S. Navy men from body circumferences and height (Report 84-11) and Prediction of percent body fat for U.S. Navy women from body circumferences and height (Report 84-29). Naval Health Research Center, San Diego. Standard error about 3.5 percentage points (men 3.52, women 3.72).
- Siri WE (1961). Body composition from fluid spaces and density: analysis of methods. In: Techniques for Measuring Body Composition. National Academy of Sciences.
- US Navy Physical Readiness Program, Guide 4: Body Composition Assessment (Feb 2025). Measuring sites.
- American Council on Exercise (ACE). Body fat percentage chart: essential fat, athletes, fitness, average and above (by sex).